My device is not connecting to the app
Note: The NC° Ring can take up to two minutes to connect. Please wait for the full two minutes before starting these troubleshooting steps.
If your NC° Ring is not connecting to the Natural Cycles app, it could mean that it is out of reach, out of battery, or asleep.
Please try the following troubleshooting steps:
- Close the NC° app
- Plug the charger into a power source, then place the NC° Ring onto it. Make sure the magnet symbol on the inside of the ring aligns right below the charger’s light indicator—you'll feel the magnets snap into place. A glowing light will confirm your ring is properly connected (it stays on even once the ring’s battery is full).
- Turn Bluetooth off in your phone’s settings, wait 5 seconds, then turn it on again
- Open your NC° app again and let the app try to find your device automatically.
If the above doesn’t work, go to phone settings → Bluetooth — if NC° Ring is listed, tap (i) → Forget this device, then try again.
Make sure you are connected to the correct NC° Ring by verifying that its serial number matches the one shown on your My Device > Device info page.
Some things to note:
- It's normal for your ring not to appear in your phone's Bluetooth settings before you connect it. Just keep it on the charger and follow the pairing steps in the app, and it will be found there.
- Once your device is connected to the app, it’s completely normal for it to show as disconnected when you aren't actively syncing. The NC° Ring is designed to store your sleep and temperature data overnight on the device itself, so it doesn't need a continuous Bluetooth connection to your phone.
⚠️ Important: If you get a new phone, you'll need to pair your ring again on the new phone. Open the NC° app on your old phone first (if you can) so all your data syncs — pairing with a new phone resets the ring and clears any unsynced nights.
My temperature data isn’t syncing
The algorithm requires at least 4 hours of sleep between 7 pm and 10 am to accurately extract your resting temperature.
-
If you see “Interrupted Sleep”, it means your sleep period was too short for a valid reading. The NC° Ring requires at least 4 hours of total sleep within the 7 pm <> 10 am window to accurately measure your temperature.
- Charge your ring and try wearing it overnight again tonight. Data should sync once you’ve had a longer sleep.
-
If you see “Not enough data”, it means your ring didn’t collect enough temperature data. This happens if:
- Your ring wasn’t worn tightly enough.
- The sensor lost contact with your skin.
-
The ring ran out of battery overnight.
- Wear the ring overnight again, making sure it sits snugly, the battery is sufficiently charged, and Bluetooth is enabled. The next morning, try syncing your data to the app.
If the above does not apply and your temperature data still isn't syncing, it could be due to a low battery or a temporary connection issue between your phone and the ring.
Please try the following steps in order, and let me know if it starts working at any point:
- Force close and reopen the Natural Cycles app.
- Toggle Bluetooth off and on in your phone's settings.
- Charge your ring for at least 10 minutes, then try reconnecting while it remains on the charger. The charger LED lights up whenever the ring is seated correctly on the charger — if the LED is off, reposition the ring.
- Forget the device in your phone's native Bluetooth settings, then go back into the app and try pairing again from scratch.
- Restart your phone.
- Make sure Bluetooth permissions are enabled for the Natural Cycles app on your phone (Settings > Natural Cycles > Bluetooth).
Still stuck?
Contact our Customer Care team with the steps you’ve tried and whether any have made a difference. Please also let us know whether the NC° Ring appears in your phone’s native Bluetooth settings.